FTM Board Club
Lattice Semiconductor
ICE40HX1K-STICK-EVN
USB thumb drive form factor evaluation board

The iCEstick Evaluation Kit is an easy to use, small size board that allows rapid prototyping of system functions at a very low cost using Lattice Semiconductor's iCE40 FPGA family.

IrDA and Digilent Pmod™ interfaces - Users can communicate to an IrDA transceiver, a Digilent Pmod™ peripheral connector for various sensor expansion options, 16 generic I/Os and LEDs.

Development Software - The iCEstick Evaluation board is supported by Lattice iCEcube2™ design software for HDL development. Programing the onboard iCE40HX-1k device's SPI flash is done with Lattice Diamond Programmer version 3.0 or higher.

Features
  • USB thumb drive form factor
  • iCE40HX-1k on board
  • 2 x 6 position Digilent Pmod™ connector for other peripheral connections
  • FTDI 2232H USB device allows iCE device programming and UART interface to a PC
  • Vishay TFDU4101 IrDA transceiver
  • Five user LEDs
  • Discera 12 Mhz MEMS oscillator
  • Micron 32 Mbit N25Q32 SPI flash
  • USB connector provides the power supply
  • 16 LVCMOS/LVTTL (3.3 V) digital I/O connections on 0.1” through-hole connections