Sensing

Sensirion

The SEK-SEN5x kit provides a convenient format for evaluating the operation of the SEN5x air quality sensor module. It performs relative humidity and temperature measurements, and tracks volatile organic compounds, nitrogen oxides, and concentrations of particulate matter. The sensor module is equipped with on-board algorithms for converting raw gas measurements to air-quality index outputs, and for accelerating and compensating humidity and temperature readings.

The kit includes:

  • SEN55 gas sensor
  • Adapter cable
  • Jumper wire set

Users of the kit also require an SEK-SensorBridge board.

Renesas

The FS3000-EVK enables the quick discovery of the sensitivity and response of the FS3000 module to air flows. The kit includes a FS3000 module adapter board, together with an extension cable to enable the engineer to take measurements at the point of interest, such as inside an air duct.

The kit is powered by a 3.3 V battery supply. It is supplied with an interface board that has an OLED display. Renesas software enables logging of the sensor’s measurement data.

STMicroelectronics

The STEVAL-MKI227KA evaluation kit is based on the LSM6DSV16X inertial module. It provides a Qvar electrostatic sensor, and three electrodes supporting finger swipe and generic functions. It is compatible with the STEVAL-MKI109V3 microcontroller motherboard. 

It is possible to configure the LSM6DSV16X by changing the position of the jumper. The kit supports the entire LSM6DSV16X pinout, and comes ready-to-use with the required decoupling capacitors on the power-supply line.

The STEVAL-MKE00xAA can be plugged onto the STEVAL-MKI227A board. This adapter is supported by the STEVAL-MKI109V3 motherboard, which includes a high performance 32-bit MCU functioning as a bridge between the sensor and a PC, on which it is possible to use the downloadable graphical user interface Unico-GUI, or dedicated software routines for customized applications.

It is also possible to plug the board onto the X-NUCLEO-IKS01A3 expansion board.



STMicroelectronics

The STEVAL-MKI230KA evaluation kit consists of the STEVAL-MKI230A main sensing board, with a square PCB, which mounts the ISM330IS 3-axis accelerometer and 3-axis gyroscope with embedded ISPU, the STEVAL-MKIGIBV5 adapter board, and a flat cable. The main board is connected to the adapter board through the flat cable to make it compatible with the STEVAL-MKI109V3.

STMicroelectronics

The STEVAL-MKI235KA evaluation kit is based on the LIS2DUXS12 inertial module with a Qvar electrostatic sensor and three different electrodes. It is compatible with the STEVAL-MKI109V3 MEMS sensing motherboard. 

The kit provides the complete LIS2DUXS12 pinout and comes ready-to-use with the required decoupling capacitors on the power-supply line.

The STEVAL-MKI109V3 motherboard includes a high-performance 32-bit microcontroller functioning as a bridge between the sensor and a PC, on which it is possible to use the downloadable graphical user interface, Unico-GUI, or dedicated software routines for custom applications.

It is also possible to plug the board into an X-NUCLEO-IKS01A3 expansion board.

1 … 5 6 7 8 9 10